Clearing A Scenario (On The Transmitter) - LEGRAND 882 15 Manual De Instrucciones

Clearing a scenario (on the TRANSMITTER)

Clear all scenarios linked to the control button
Press LEARN
Clear all scenarios linked to this product
Press LEARN
Caution
When clearing the settings of one or all the control keys, this key is (these keys are) reset. This means that keys reset in
this way move back to radio media.
Remember the restart the "Procedure for choice of media on a control key" described on page 14 if you want to
control infrared products.
Troubleshooting
Problem
During learning, the Learn indicator
goes off 10 minutes after the start of
the learning procedure.
During learning, the receiver's Learn
indicators goes off where if had been
blinking slowly, but the 10 minutes
deadline has not yet been reached.
After pressing the Learn key, pressing
the control key does not produce a
fast blink on the transmitter.
The learn key is off.
During learning on the receiver, the
receiver's Learn indicator stays on
steadily for 5 seconds.
5 s
Press the control button
and hold down for 10 s
5 s
Press LEARN and hold
down for 10 s
17
Cause
The learning procedure terminates
after 10 minutes if no control key is
pressed.
Pressing the control key on the
receiver should be done within one
minute of pressing the Learn key
on the receiver.
The learning procedure terminates
after 1 minute if no control key on
the transmitter is pressed after
pressing the Learn key.
The transmitter which initiated the
learn procedure is not compatible
with the receiver.
18
The scenario is cleared
The product returns
to factory settings
Solution
Restart learning.
Press the Learn key and continue the
learning procedure by pressing a
control key within less than one
minute.
Restart learning.
Perform learning between mutually
compatible products.