Hydraulic System; Storage Instructions - Enerpac VE33 Manual De Instrucciones

8.0 HYDRAULIC SYSTEM

1. Keep all hydraulic components free of dirt,
grease, chips, etc.
2. Keep the hydraulic component operating in areas
that are uncluttered and free of unnecessary
equipment.
3. Periodically check your hydraulic system for
possible loose connections, leaks, etc. Replace
or properly repair damaged or leaking hydraulic
components immediately.
4. Check hydraulic oil in your hydraulic system
every 40 hours of operation or more frequently
in unusually dirty or dusty areas.
5. Oil temperature must be maintained less than
or equal to 150 °F (65 °C) by way of a heat
exchanger or other methods.
115 volt power cord
(115VAC version shown)
.250-18 NPTF pump
pressure gauge port "GP"
(NOTE: This port not present
on all valve manifolds.)
Control station connection
.250-18 NPTF pump
pressure gauge port
"GP"
(24VDC version shown)
Fig. 3, 3-Way Valve, Pump Mounted VE33/VE33-115

9.0 STORAGE INSTRUCTIONS

In the event that the unit would be stored for any
prolonged period of time (30 days or more), prepare
the unit as follows:
1. Wipe the entire unit clean.
2. Disconnect all hydraulic and electrical lines to
prevent accidental operation.
3. Cover the unit with some kind of protective
cover.
4. Store in a clean, dry environment that is NOT
exposed to extreme temperatures.
4x Ø .38 [9.6] mounting holes
M8 X 60 SHCS (shown)
User adjustable
relief valve
.250-18 NPTF
gauge port "GA"
.375-18 NPTF
Advance/Retract port
4
.375-18 NPTF
auxiliary tank
return "T"