Intended Use; Hazard And Warning Information - Renfert SILENT TS2 Guia De Inicio Rapido

Introduction
This Quick Start Guide contains instructions on the operation of the product and relevant safety informa-
tion.
Detailed information on the product can be found in the operating instructions which are available for
download on our website at
Symbols
In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current
Attention
Disregarding this warning may result in damage to equipment..
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
Other symbols are explained as they occur.
Safety

Intended Use

The product is intended for indoor use for the extraction of dry, non-explosive dust particles. The ambient
temperature must be between 5 - 40 °C.
This device is intended solely for commercial use in a dental laboratory.
The intended use also includes compliance with the instructions specified by the manufacturer concerning
operation, servicing and maintenance.

Hazard and Warning Information

General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device can
no longer be guaranteed.
► Only operate the device under supervision.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► The product does not contain any parts inside which require servicing.
► Defective devices must be put out of service immediately. Remove the mains plug and ensure the
device is not used. Send the device for repair!
► The product may not be opened, except as instructed below.
Specific Information
► Please observe the national regulations and permitted exposure to dust in a working environment.
Please ask the "National Institute for Occupational Safety and Health" or other responsible au-
thority
► It is necessary to wear suitable personal protective equipment when emptying the dust drawer or
cleaning, depending on the type of extracted material.
► Do not extract flammable or explosive gasses, fumes or dust.
► Do not extract hot materials.
► Do not extract liquids.
► Dispose of extracted material according to local statutory regulations.
www.renfert.com."
- 1 -
EN