Mellerware Rider Pro Manual Del Usuario página 9

RIDER PRO ANIMAL model:
- Motorized brush "Power Brush"
- 2in1 upholstery nozzle
- Crevice tool
- Pet brush
- Sofa/bed motorized brush
RIDER PRO CLEAN model:
- Motorized brush "Power Brush"
- 2in1 upholstery nozzle
- Crevice tool
- Motorized brush "Turbo Brush"
- Water tank
RIDER PRO FULL SET model:
- Motorized brush "Power Brush"
- 2in1 upholstery nozzle
- Crevice tool
- Pet brush
- Sofa/bed motorized brush
- Motorized brush "Turbo Brush"
- Water tank
FITTING THE WATER TANK TO THE
MOTORIZED BRUSH "TURBO BRUSH"
(ONLY IN RIDER PRO CLEAN MODEL OR
RIDER PRO FULL SET MODEL)
- The water tank (g) can only be used with the
"Turbo Brush" motorized brush (f).
- Fill the water tank through the opening mark
(Fig.9).
- Fit the brush over the water tank.
- To let the water out, press the button on the left
side of the tank with your foot.
- Remove the mop and clean (Fig.10).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Remove the dust tank from the hand vacuum
by pressing the release button (H). (Fig.3).
- Open the lid of the dust tank (G) and empty the
contents into the appropriate waste disposal
receptacle (Fig.4).
- Close the lid of the dust tank.
CHANGING THE FILTERS:
- Air entry filter, it is advisable to be changed
at least once a year or every 50 hours of the
appliance's use.
- Air outlet HEPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen...), it is advisable to change it a least
once a year or after every 50 hours of use.
AIR INLET FILTER REMOVAL:
- Remove the dust tank from the hand vacuum
by pressing the release button (H). (Fig.3).
- Remove the filter (Fig.5).
- To reassemble the filter, proceed with the
above instructions, in reverse order.
AIR OUTLET FILTER REMOVAL:
- Open the filter cover (Fig.6).
- Remove the filter.
- To reassemble the filter, proceed with the
above instructions, in reverse order.
"POWER BRUSH" REMOVAL:
- Turn the rotary knob, located at the bottom
of the brush, counterclockwise to remove the
brush.
- Remove the brush and clean.
- To reassemble, follow the above instructions
but in reverse.
"TURBO BRUSH" REMOVAL (ONLY IN RIDER
PRO CLEAN MODEL AND RIDER PRO FULL
SET MODEL):
- Open the cover located on the bottom of the
brush (Fig.7).