Toshiba MMY-MAP0806HT8P-E Manual De Instrucciones página 43

■
Ceiling type
Vertical adjustment
▼ When cooling
Point the louver horizontally to send cool air across the
entire room.
▼ When heating
Point the louver downward to send heated air to the
fl oor.
• The louver automatically points upward when
running is stopped.
• In pre-heating mode, the louver points upward. The
swing indication appears on the remote controller
even in pre-heating mode, but the actual swing starts
only after pre-heating is complete.
Horizontal air fl ow adjustment
To change the horizontal air fl ow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
• When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
• When the horizontal louver is pointing horizontally
in HEAT mode, the air may not warm up the room
evenly.
83-EN
1117102201-2_EN.indd 42 1117102201-2_EN.indd 42
■
1-way cassette (YH series),
and fl oor standing types
◆ Setting the direction and
swinging
1
Push the button during running.
If 1 remote controller controls 2 or more indoor
units, you can confi gure the direction setting for
each unit individually.
Push the button again while the louver
is swinging.
2
You can stop the louver in your preferred
position.
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
FILTER L L
RESET TEST SET CL SWING/FIX UNIT LOUVER
1,2
Unit select
◆ Unit select
• When two or more indoor units are controlled with
one remote controller, the louver direction can be set
for each indoor unit by selecting them individually.
• To set louver direction individually, push the
button (left side of the button) to display an indoor
unit number in the control group. Then set the louver
direction of the displayed indoor unit.
• When no indoor unit number is displayed, all
indoor units in the control group can be controlled
simultaneously.
• Each time you push the (left side of the
button), the indication changes as follows:
No Unit No. Unit No.
display 1-1 1-2
Unit No. Unit No.
1-4 1-3
■
1-way cassette type
(YH series)
Vertical adjustment
▼ When cooling
Point the louver horizontally to send cool air across the
entire room.
▼ When heating (for heat-pump model only)
Point the louver downward to send heated air to the
fl oor.
Horizontal adjustment
To send air horizontally, point the vertical grilles inside
the louver in your preferred direction.
NOTE
To improve the cooling/heating performance, change
the louver angle for each running mode.
– 42 –
■
Floor standing type
Vertical adjustment
▼ When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
▼ When heating (for heat-pump model only)
Move the louver manually and point it downward to
send heated air to the fl oor.
Horizontal adjustment
▼ Sending air in different directions
Lift up the vertical louvers slightly and point them in
your preferred directions.
2
1
In this case, do not use
the auto swing function.
84-EN
6/30/2559 BE 15:41 6/30/2559 BE 15:41