4-3 How to operate
*
Set the clock and other operation details (refer to page 7 for operation setting details) before setting the timer.
AIR
SWING
TIMER
LOCAL
MANUAL
OFF / ON
CZ-RD51P
AIR
SWING
TIMER
SELECT
AUTO
MANUAL
SET
TEST RUN CLOCK CANCEL
Setting timer operation
Timer operation can be used to start and stop the indoor unit automatically.
To set the OFF timer
Press C to activate the OFF time setting.
1
The current time will flash and OFF will appear in
the display.
(Example)
TIMER
OFF
• The display will switch from OFF to ON to current time
accordingly by pressing the SELECT button.
Press B to set the timer.
2
To set a later time, press the L button.
To set an earlier time, press the M button.
Setting is possible within the range of 0:00 to
23:50, in interval of 10 minutes.
The setting changes more rapidly if the buttons
are pressed continuously.
Press D to complete the settings.
3
(Example)
TIMER
OFF
(with timer operation)
FAN
OPE-
RATION
TEMP
SPEED
MED
COOL
FAN
OPE-
TEMP
SPEED
RATION
UP
DOWN
FILTER
CHECK
A/C No.
RESET
(The display shows an
example of operation stops
at 23:00)
Setting the current time
Example: setting the time to 10:36 a.m.
Press A to activate the setting time.
1
(Example)
Press B to set the desired time.
2
To set a later time, press the L button.
To set an earlier time, press the M button.
The setting changes more rapidly if the buttons
are pressed continuously.
Press A once more to complete the settings.
3
(Example)
To set the ON timer
Press C until ON display and the time
1
flashes.
2
Repeat step 2 and 3 of procedures "To set the
OFF timer" to complete the ON time settings.
NOTES
•
If both ON and OFF timers are set, the time nearer to the
current time will be activated first.
•
To cancel the timer setting, press the CANCEL button.
•
If the main power is switched off for an hour, the time and
timer will need to be set again.
•
If the setting procedures are not completed within 1
minute, the setting will be cleared automatically.
– 8 –
(Time display will flash.)
TIMER
(The time display will stop
TIMER
flashing.)