Panasonic S-36PU2E5A Manual Del Usuario página 23

3 Select the "Unit no." by pressing the
button for changes.
4 Select the "Code no." by pressing the
button.
Change the "Code no." to "5D" by pressing the
button (or keeping it pressed).
5 Select the "Set data" by pressing the
button.
Select one of the "Set data" in "Table for DC Fan
Motor Tap Settings" by pressing the
button.
Then press the button.
6 Press the
button.
The "Exit detailed settings and restart?" (Detailed setting-
end) screen appears on the LCD display.
Select "YES" and press the
If you wish to change the selected indoor unit, follow the
step 2.
or
or
or
or
or
button.
23
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
3 Designate the item code
Temperature Setting
4 Press the timer time
desired setting data.
* For item codes and setting data, refer to "Table for DC
Fan Motor Tap Settings".
5 Press the
button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step 2.
6 Press the
button to return to normal remote
controller display.
°
3
°
A
6
(4) Setting the Flap Separately
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
, and buttons
button to set.
by adjusting the
/ buttons.
/ buttons to select the
4
2
4
2
5
1
Flap