Mopar 82212695 Manual De Instrucciones página 4

4
NOTE: The specified cavities in the TIPM may be populated. If so, the existing wires must be removed using a
terminal removal kit, or equivalent to install the fog lamp kit wires.
NOTE: The location of the jumper harness wires (RH
and LH fog lamp 12V power feeds) are not placement
sensitive between TIPM connector C­11 cavities 5, 6.
19. Insert the fog lamp jumper harness wire terminals into
TIPM connector C­11 cavities 5 and 6.
20. Seat the TPA on the face of the TIPM connector C­11.
21. Connect TIPM harness connector C­11 (3).
NOTE: Make sure the jumper harness is available for­
ward of the TIPM.
22. Position the TIPM (1) and install on the three retaining
clips (2). Lift on the TIPM (1) to make sure the retain­
ing clips (2) are secure.
Jan 17, 2011
www.mopar.com
K6861209