Outlet Programming - Monster Power Signature PRO AVS2000 Manual Del Propietário

Tabla de contenido

Idiomas disponibles

Outlet banks 1–4 of the Signature PRO AVS 2000 are "switched" outlets. This means the components plugged into these

outlets will only receive power when your Signature PRO AVS 2000 is turned on. These outlets are also "timed," enabling

sequential power activation of components plugged into the switched outlets. Outlets will not turn on or off until after

a short delay. Without sequential turn-on, you'd power all your devices at once, causing unnecessary electrical stresses

known as "turn-on surge." Turn-on surges can overheat system connections, pop circuit breakers, and degrade overall

system performance. By sequentially powering your high power loads, you can prevent turn-on surges and deliver all

the stable voltage needed to maintain peak performance.

The four switched outlets on the Signature PRO AVS 2000 can be individually programmed to delay power-up of connected

components from 1 to 6 seconds. In order to program each outlet, you must use the slide switches seen in Figure 1.

The Delay Time Multiplier will double the time

selected for that bank when set to x2.

The Delay Time switches select

the delay time for that bank.

��

�

��

�

��

�

��

OUTLET PROGRAMMING

��

Figure 1

Delay time left / Multiplier left

= 1 second delay (1x1=1)

Delay time left / Multiplier right

= 2 second delay (1x2=2)

Delay time right / Multiplier left

= 3 second delay (3x1=3)

Delay time right / Multiplier right

��

= 6 second delay (3x2=6)

Tabla de Contenido

Tabla de contenido