Troubleshooting - Monster Power Signature PRO AVS2000 Manual Del Propietário

Symptom Possible Cause
The Signature PRO The Signature PRO AVS 2000
AVS 2000 is not is not turned On.
receiving power.
Too many devices are connected,
causing an overload, tripping
the thermal circuit breaker.
Please note:
The total power consumption on
all the components powered by
a single Signature PRO AVS 2000
should not exceed 2400 watts
continuous.

TROUBLESHOOTING

Remedy
• Make sure the Signature PRO AVS 2000's AC
power plug is plugged into a properly grounded
120V wall outlet.
• Press the ON button on the Signature PRO AVS 2000.
• In some households, a wall switch may need
to be thrown to make the wall outlet come alive.
Try turning on the light switches located near the
wall outlet powering the Signature PRO AVS 2000 .
• Disconnect any component that maybe overloading
the Signature PRO AVS 2000.
• Press the Signature PRO AVS 2000's thermal circuit
breaker (labeled Breaker 20A on the back panel)
button in to reset. Please allow 10 minutes from
the time the circuit breaker is initially tripped before
attempting to reset. If you reset too soon, the breaker
will prematurely sense power overload and not allow
the unit to operate.
9