Zenit UNIQA Manual De Primera Instalación página 45

better together
Enclosure type M08S - M08L - M10S - M10L - M12N - M13N - M15N - M17N - M21S - M21L
1. Position the pump on a firm, even surface;Use a suitable
lifting system of appropriate size.
Secure it to prevent it from rolling or rocking.
2. Identify the plugs of the pump's oil sump.
4. Allow the oil to drain into a vessel of suitable size, transparent if possible.
5. Place the vessel containing the oil on a horizontal surface and let it stand for a few
minutes to allow any water in it to settle to the bottom:
•
Oil clean and free from water: the mechanical seal is in good condition and new
oil can be placed in the system.
•
Oil with a very little water: this may be due to bedding-in of the mechanical seal
during the initial operating hours, creating a negligible amount of water.
•
Oil containing water and dirt; the mechanical seal must be inspected and
replaced with a new one. The replacement must be made by an authorised
Service Centre;
6. Lay the pump horizontal on the workbench
7. Fill the mechanical seal sump with biodegradable lubricating oil having viscosity
index 190.
Zenit recommends:
- CASTROL PRODUCT L 320
- TOTAL Bio Hydraulic TMP FR46
If the recommended oil is not available, contact Zenit.
Enclosure type
G05M
G05L
G06S - G06L
G07S - G07L
G08L
G10S - G10L
8. Screw the top plug onto the oil sump.
warning!
Use Loctite 243 threadlocker
Enclosure type
G05M - G05L
G06S - G06L
G07S - G07L
G08L
G10S - G10L
Version WET
3. Unscrew the plug on the top of the oil sump.
First installation manual – Translation of original instructions
Mechanical seal sump
oil capacity (ml)
140
215
310
370
570
1800
Oil sump plug
1/8" NPT
3/8" DIN 906
EN
45