Atlas Copco Cobra Serie Instrucciones De Seguridad Y De Funcionamiento página 19

COBRA MK1, TT, TT-AWD
3. Place the starter cord in the recess (A) in the
pulley.
A
4. Rotate the pulley until all tension is released.
5. Remove the lock ring and lift out the pulley
complete with spring and starter cord.
Fitting a new starter cord
6.
WARNING Spring tension
The starter spring may cause personal injury by
striking the operator or other persons.
Wear impact resistant eye protection with side
►
protection and gloves.
Place the knot on the starter spring in the recess
on the inside of the pulley and wind in the starter
spring (anti-clockwise).
© 2008 Atlas Copco Construction Tools AB | No. 9800 0665 90 | 2008-10-28
Safety and operating instructions
7. If the starter spring must be rewound, place the
spring-hook in the pulley groove and wind on the
spring anti-clockwise. If the spring must be
replaced, position the spring-hook above the
groove in the starter pulley. Leave the safety ring
in place, press down the spring into the starter
pulley.
8. Wind up the starter cord onto the pulley leaving
5 cm (2 in.) of slack. Locate the end of the spring
in the bushing groove, press the starter pulley
onto the bushing. Replace the lock ring.
Pre-load the starting spring
9. Place the notch in the pulley edge in line with the
starter cord guide and place the starter cord in
the notch.
10. Fit the lock ring.
11. Rotate the pulley 1 turn anti-clockwise.
12. Release the starter cord slowly.
19