Sigma EF-500 Instrucciones página 19

LCD PANEL ILLUMINATION
When you press the
LIGHT
on longer than 8sec, if you press the
TTL AUTO FLASH
In the TTL AUTO Mode, the camera will control the amount of flash lighting to provide the appropriate
exposure for the subject.
1. Set the camera's exposure mode to P Mode. (In the case of SA-300,
SA-300N and SA-5 set to "
2. Turn on the power switch of the flash, the TTL mark will appear on the
LCD panel and flash will start charging. (If TTL mark does not appear,
depress the MODE button several times to select the TTL mode).
3. Focus on your subject.
4. Check that the subject is located within the effective distance range, indicated on the LCD panel.
5. Press the shutter button, after the flash is fully charged.
When the flash is fully charged, the ready light in the viewfinder, and
appears on the flash unit.
■ The TTL exposure is controlled by the S-TTL system of the digital camera.
If the flash is set to TTL, the character "d" (digital) will be displayed on the
LCD panel.
■ When the camera receives the appropriate exposure, the TTL mark on the LCD panel will appear for 5
seconds. If this indication does not appear, the flash illumination is not enough for that situation. Please
re-take the picture, at a closer distance.
■ The AF Auxiliary Light will turn on automatically as you focus on a subject in a dark area. The effective
range of the AF Auxiliary Light is up to about 0.7meter to 9meter (2.3-29.5 feet).
■ If the SA-300, SA-300N and SA-5 cameras, are set to "
switch to TTL mode only. For other camera exposure modes, the flash will be set to the last chosen mode
each time.
■ When the flash is fully charged, the flash mark will appear in the finder. If the shutter is released before the
flash is fully charged, the flash will not fire, and the camera will take the picture at a slow shutter speed.
■ If the flash range is below than 0.5meter (1.6 feet), the distance range bar marks on the LCD panel will
blink.
USING FLASH IN OTHER CAMERA MODES
Shutter Speed Priority Setting
By selecting the S mode of the camera, you can set the shutter speed from 30sec. to 1/X sync speed.
When you set the desired shutter speed, the camera will select the appropriate aperture value for the
background. If the subject is too light or too dark, the aperture value indicator will blink and show the limit
values (maximum or minimum aperture). In such as case, the camera proceeds to take flash photograph at
the limit value. Thus, the main subject in the picture may be exposed correctly, but the background will
become under or over exposed.
Aperture Priority Setting
By selecting the A mode of your camera, the camera will select the appropriate shutter speed for the
background. If the subject is too bright or too dark, the shutter speed indicator will blink and show the limit
highest or slowest shutter speed value. The highest shutter speed will be limited to the camera's normal
flash synchronization speed. In such a case, the camera proceeds to take a flash photograph at the limit
value. Thus, the main subject in a picture may be exposed correctly, but the background will become under
or overexposed.
When used with M Mode
You can set the desired shutter speed and aperture value. You can set the shutter speed from top sync
speed to bulb. If you adjust the exposure according to the exposure meter indication, the camera will work
as for Daylight synchronization flash or slow, synchronization.
19
button, the LCD panel will illuminate for about 8 seconds. The illumination stays
button once again.
LIGHT
" fully automatic mode)
" fully automatic mode, Flash will automatically