Troubleshooting - Sub-Zero IW-30C Guía De Uso Y Cuidado

T R O U B LE S HO O T I NG

Troubleshooting

SE RVI C E I NDI CAT O R
flashes in control panel display.
• Verify condenser is clean.
• Turn unit off at the control panel, then on. If indicator
continues to flash, contact Sub-Zero Factory Certified
Service.
U N IT O P E R AT I O N
No lights or cooling.
• Verify power is on.
• Verify electrical power to unit and home circuit breaker
is on.
No lights.
• Door/drawer may have been left ajar which has disabled
lights to eliminate excess heat. If lights are out, close
door/drawer for one hour. If lights are still out, contact
Sub-Zero Factory Certified Service.
• Cabinet lighting must be replaced by Sub-Zero Factory
Certified Service.
Frost, condensation or ice build up inside unit.
• Verify condenser is clean.
• Verify door/drawer is closing properly.
• Verify door/drawer has not been left ajar.
• Verify door/drawer gasket does not have rips or tears. If
it does, contact Sub-Zero Factory Certified Service.
• If icing is heavy, turn unit off and use a hair dryer to melt
ice. Hair dryer should be set on low and kept moving
at all times. Once ice has melted, wipe up water with a
cloth or paper towel.
High temperatures, unit runs excessively or unit giving
off too much heat.
• Verify condenser is clean.
• Verify door/drawer is closing properly.
• Verify door/drawer has not been left ajar.
• Increased ambient temperatures may cause compres-
sors to run longer.
• If temperature display shows 45° and 55°, but is not
cooling, unit may be in showroom mode. Contact
Sub-Zero Customer Care at 800-222-7820.
O D OR
• Unit should be cleaned before using for the first time.
This will clear any odors that may have been trapped
during shipping.
• Uncovered food could create odor which may require
cleaning.
|
subzero.com 13