Instructions For Use - English; Product Description; Basic Safety Information - DMG Honigum Pro Instrucciones De Empleo

Instructions for use

Product description

Honigum Pro-Light Scan is a scannable correction
impression material based on addition-cured
silicones. The material is suitable for all scanners
designed for scanning impression materials (e.g.
the D700 dental scanner from 3Shape). Additional
surface treatment is not required.
The material is available in the Automix cartridge.
Indications
• Crown and bridge impressions
• Inlay and onlay impressions

Basic safety information

• For dental use only!
• Keep out of the reach of children!
Instructions for use
English
• The specified working times (see "Technical
data") apply at a room temperature of
23 °C/72 °F and a normal relative humidity of
50 %. Higher temperatures shorten these
times while lower temperatures increase
them.
• Rinse off residual retraction solution
thoroughly with water, otherwise this may
increase the setting time in some instances.
• Do not allow the impression to come into
contact with organic solvents or liquids
containing solvents as this may otherwise
result in swelling of the material, leading to
inaccuracies in the cast.
• Do not allow the impression material to
come into contact with latex gloves. DMG
recommends the use of PVC or PE-based
gloves.
• Do not combine the material with
condensation-curing silicone or polyether
impression materials.
11