Technical Data - DMG Honigum Pro Instrucciones De Empleo

Technical data

Honigum Pro-Light Scan
Working time 1 [min]
Intra-oral working time
Setting time in the mouth [min]
Dimensional change after 24 hours [%] ≤ 0.35
Residual compression set [%]
Compression set [%]
1 The specified times apply at a room temperature of 23 °C and a
normal relative humidity of 50 %. Higher temperatures shorten
these times while lower temperatures increase them.
The working time describes the period after mixing has begun
until the maximum time by which the impression tray must be
positioned in the patient's mouth.
2
The specified times apply after mixing has begun for a
temperature of 35°C.
16
≤ 2:45
2
[min] ≤ 1:00
≥ 3:15
≤ 0.25
≈ 4.0
Disinfection of the Automix-
Dispenser
The Automix-Dispenser can be reused after
disinfection, although it should be replaced if
there are visible signs of wear.
Disinfection can be carried out using a commercially
available dipping disinfectant. DMG recommends
using only disinfectant solutions listed by the RKI
(Robert Koch Institute). The Automix-Dispenser
is also autoclavable.
Composition
Vinyl polysiloxanes, silicon dioxide, pigments,
additives, platinum catalyst
Classification
ISO 4823:2000, Type 3: Light-bodied consistency
Storage and shelf life
Store in a dry place at room temperature
(15 – 25 °C / 59 – 77 °F)!
Do not store in the fridge or freezer!