Ice Maker Operation; Ice And Water Dispenser (Dispenser Models) - Sub-Zero BI42UFDIDSTH Guía De Uso Y Cuidado

O PE RAT I O N

Ice Maker Operation

To initiate ice production, touch ICE MAKER on the control
panel. After initial start-up, discard the first few batches
of ice. The ice may contain impurities from new plumbing
connections.
The ice maker will cycle every two hours. If ice is not used
regularly it may fuse together. To avoid, discard ice and
allow ice maker to replenish.
Sabbath
This appliance is certified by Star-K to meet strict religious
regulations in conjunction with specific instructions found
on www.star-k.org.
To initiate Sabbath mode, while the unit is on, touch POWER
on the control panel. "OFF" appears in the control panel
display. Touch and hold POWER for 10 seconds until "SAb"
appears in the display indicating Sabbath mode has been
initiated. Lights, ice maker, door alarm, and dispenser (if
applicable) will be disabled. To return to normal operating
conditions, touch POWER.
|
10 Sub-Zero Customer Care 800.222.7820
Ice and Water Dispenser
The first time the water dispenser is used, purge the water
system and storage tank for three minutes. This will clear
any air in the system, along with impurities from new
plumbing connections.
Initially, for water to dispense properly, press and hold
WATER or the water dispenser button until water flows from
the dispenser. It may need to be pressed for 60 seconds for
water to fill the internal reservoir tank.
The chilled water reservoir tank holds approximately 40 oz
of filtered water. It may take several hours to chill the
(1.2 L)
water to refrigerator temperature during the original fill and
after a large amount of water is dispensed.
CAUTION
Limit continuous ice and water dispenser operation to
seven minutes or less.