First Start And Internet Connection - CHAFFOTEAUX ChaffoLINK Instrucciones De Instalacion Y Uso

6. FIRST IGNITION AND INTERNET CONNECTION
The following describes how to connect Chaff olink to the internet, using two diff er-
ent procedures, depending on whether you are using an ADSL or GPRS gateway.
6.1 Connection via ADSL Gateway
Chaff olink is able to use a LAN or
Wi-Fi connection in order to connect
to an ADSL router. If you are using a
WiFi connection, skip to step 2 of the
following confi guration procedure.
1. With Chaff olink
connected to the mains power,
open the front panel by unscrewing
the two screws and connect the
LAN cable to its connector (A).
Connect the other end of the
cable to the ADSL router and re-
close the front panel.
2. Provide mains power to the
gateway and press the ON/OFF
button.
For several minutes the gateway
performs its startup procedure,
during which all the LEDs fl ash in
sequence in blue. On completion,
the WEB led remains stable on
red while the BUS and Serial LEDs
remain green.
3. Once you have checked that the
ADSL router is running, press
and hold the initial confi guration
button (for at least 5 seconds) until
the WEB LED fl ashes green.
At this point the gateway has
created a new WiFi network that
remains active for 10 minutes, after
which you will need to repeat the
procedure.
off and not
A
NOTE:
Chaff olink supports the following
encryption for Wi-Fi networks:
- WEP
- WPA/WPA2 Personal
220V
BUS BUS
TA1
B T B T
65