Hardware Installation - Conceptronic C300Ri Manual De Usuario

2. The 300
Nr Description
A. R-SMA Connector
B. Activity LED
C. PCI connector
Before you can install the drivers & software, you need to insert the 300
computer.

Turn off your computer and disconnect the computer from the AC outlet.

Open your computer case by removing the screws from the back and remove the panel.

Find a free PCI slot and remove the protective plate from your computer case.

Insert the 300 Wireless PCI Card gently in a free PCI slot and fix it with a screw to your computer
N
casing.

Close your computer case and assemble the 2 antenna‟s to the 300

Turn on your computer.
The computer will recognize new hardware and shows the „New Hardware Wizard‟.

Ignore this wizard or click on "Cancel" to close this wizard.
You can now proceed with the driver & software installation, described in chapter 4.
Note: When using Windows 7, you may skip chapter 4, since windows 7 will automatically install the
needed native drivers. However, when using these native drivers, the WPS functionality and the
Conceptronic Wireless Network Configuration Utility are not available. When you choose to skip
chapter 4, you can also skip chapter 5.1 ~ 5.4 and continue to chapter 5.5.
Wireless PCI Card explained
N
Status
-
Off
Flashing randomly
-

3. Hardware installation

Explanation
Connector for the wireless antenna.
The adapter is not connected to a network.
The adapter is connected to a network and
sending or receiving data.
Connector to put the C300Ri in your computer.
Wireless PCI Card in your
N
Wireless PCI Card.
N
ENGLISH
11