Sauder Palladia 411626 Manual Del Usuario página 16

Step 12
Carefully turn your unit over onto its front edges. Unfold the BACK (H3)
å
and lay it over your unit.
Make equal margins along all four edges of the BACK (H3). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the BACK (H3) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
SHELF (G) and LOWER UPRIGHT (C).
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Fasten two TIE PLATES (3G) to the BASE (L) and LOWER PLINTHS (R2).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
Push the FOOT (3E) into the hole in the BOTTOM (F).
å
R2
3G
Page 16
H3
F
3E
L
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
This punch out must
over the SHELF (G) and
be located here.
LOWER UPRIGHT (C).
R2
411626
1N
NAIL
(48 used for the BACK)
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
www.sauder.com/services
1S