Sauder Palladia 411626 Manual Del Usuario página 18

Step 14
Carefully stand your unit upright.
å
With a hammer tap four SHELF SNAPS (6R) into the
å
holes in the ADJUSTABLE SHELF (J2) as shown in the
upper diagram.
Insert four METAL PINS (1R) into the hole locations of your
å
choice in the LEFT END (B) and LOWER UPRIGHT (C).
Set the ADJUSTABLE SHELF onto the METAL PINS so
å
the SHELF SNAPS are resting on the METAL PINS. Push
on the SHELF until each METAL PIN "snaps" into the
SHELF SNAPS.
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (I) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (33K) to the DOOR (I). Use a BLACK
å
1-1/8" MACHINE SCREW (21S).
See the next step for DOOR adjustments.
å
Finished surface
33K
21S
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
Page 18
J2
B
I
1R
(4 used)
411626
Hinge
6R
J2
C
Stop
Mounting
screw
6R
www.sauder.com/services