Emmaljunga NXT 90 Instrucciones página 29

Go Double Adaptor
5.3 Attach the car seat to the second adaptor in the higher position.
5.4 Correctly attached. Maximum load for each car seat: 13 kg.
WARNING Never attach the car seats + car seat adaptors in any other way
than as shown in the picture.
WARNING It is important that the safety locking knob is in place and in the
locked position. Risk of injury and tipping hazard can arise from misuse.
(6) Removing the Go Double Adaptor
6.1 Remove the seat unit/carrycot /car seat out of the adaptor. Push the Go
Double Adaptor ends away from the chassis. Note that before the pram can
be folded seat unit/carrycot and adaptors have to be removed. The Go Dou-
ble has to be removed before the chassis can be folded.
6.2 Pull the adaptor clips from the chassis bar.
6.3 Pull the ring on the adaptor and lift it out from the chassis
(7)WARNING
• Seat units, carrycots or car seats + car seat adaptors shall not be used in
any other combinations other than those shown in the pictures in this manual
(pictures 7.1-7.4).
• Note that the pram's stability is immediately affected if you change the
weight distribution on the Go Double. Be aware that the risk of tipping in-
creases as soon as you attach/remove seat units, carrycots, car seats or place
children in/remove children from the pram.
• When using the Go Double never release your hands from the handle of the
pram.
• Always park on level surfaces.
• Always remove the heaviest child from the pram first.
(8) Using the Curb Lifter
8.1 For ease when you are going over a curb. Attach the Curb Lifter on the
rear chassis bar. Either on the left or right side.
8.2 Lower the Curb Lifter towards the chassis axel.
8.3 The Curb Lifter is used as a lever by pushing down with the foot to lift
the front wheels. WARNING When using never release your hands from the
handle of the pram. Use Curb Lifter with caution.
8.4 When Curb Lifter is not in use, fold it up along the side of the chassis.
29
NXT90 Go Double Adaptor v 1.4