Hub-To-Switch Installation; Hub-To-Switch Installation (Without Uplink Port) - Allied Telesyn AT-FS704 Guia De Instalacion

Tabla de contenido

Publicidad

Hub-to-Switch Installation

A hub (10/100Base-TX) can be connected to the AT-FS704 using a two-pair
Category 5 UTP/STP RJ45 straight cable. Connect the hub uplink (MDI) port
to any of the switch (MDI-X) ports, 1X-4X. See Figure 7.
POWER
10BASE-T/100BASE-TX
4 PORT ETHERNET SWITCH
Figure 7 AT-FS704 Switch Connected to a 10/100Base-TX Hub

Hub-to-Switch Installation (without uplink port)

If a hub is not equipped with an uplink (MDI) port, then connection can be
made using either straight cable or crossover cable (see "Appendix A, Technical
Specifications" for cable requirements). Figure 8 demonstrates connection with
straight or crossover cable.
POWER
10BASE-T/100BASE-TX
4 PORT ETHERNET SWITCH
Straight Cable
Figure 8 Switch Connected to Hub without Uplink (MDI) Port
1
2
3
4
=
1
X
100M
LINK/ACT
FULL DUP
COLN
To HUB
To PC
1
2
3
4
=
1
X
100M
LINK/ACT
FULL DUP
COLN
To HUB
To PC
2X
3X
4X
2X
3X
4X
Crossover Cable
AT-FS704 Installation Guide
HUB
11

Publicidad

Tabla de contenido
loading

Tabla de contenido