Electrical Safety And Installation Requirements - Allied Telesyn AT-FS704 Guia De Instalacion

Tabla de contenido

Publicidad

Electrical Safety and Installation Requirements

STANDARDS: This product meets the following standards
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and , if
not installed and used in accordance with this instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can
void your right to operate this equipment.
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
WARNING: In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
RFI Emission
WARNING: This product requires shielded cables to comply with Class A emission limits. If not used
with shielded cables, this product may cause radio interference in which case the user may be
required to take adequate measures.
Immunity
SAFETY
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock , do not remove cover. No user-serviceable parts inside. This unit
contains HAZARDOUS VOLTAGES and should only be opened by a trained and qualified
technician. To avoid the possibility of ELECTRIC SHOCK disconnect electric power to the product
before connecting or disconnecting the LAN cables.
LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of LIGHTNING ACTIVITY.
INSTALLATION
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
U.S. Federal Communications Commission
Canadian Department of Communications
EN55022 Class A
EN50082-1
iii

Publicidad

Tabla de contenido
loading

Tabla de contenido