Assembly And Usage Of Carrycot - Emmaljunga Viking Manual De Instrucciones

Assembly and usage of carrycot

1
2
"Klick" "Klick"
1
2
2
2
3
1
3
2
1
5
4
6
5
7
8
62
Assembly of pram body
• Remove plastic covers from mattress and fabrics and discard. The
bottom of the carrycot is made out of wood.
WARNING
• Risk of suffocation. Do not let your children play with the plastic
bag.
1
Assembly of pram body
• In order to extend the pram body, slide the metal bar along the
carrycot base until it clicks into one of the plastic recievers.
• Pull one side of each metal bar into position (1) and then the other
side (2) so that both sides clicks into the plastic recievers (3).
• Repeat the same steps with the metal bar on the other side of the
pram body.
WARNING
• Before using the carrycot, make sure that the metal bars have
clicked into all four plastic recievers (3) so that the frame of the
pram body is held firmly in place.
4
Folding the carrycot
• Lift the mattress.
• Push down the button on the plastic part (4).
• Push the metal bar past the button (5).
• Repeat same steps on all four corners on the carrycot base.
• Slide the metal bars along the bottom and fold the carrycot base.
• Turn over the backrest (6) to its layback position. (Available on cer-
tain models only)
Adjusting the Backrest (Available on certain models only)
• Raise the backrest (7), push the plastic legs (8) so that it rests
against the metal support bars.
Viking v. 3.0