Advanced Configuration (Via Pc) - Vimar Elvox 41001 Instrucciones De Instalación

will group the buttons for the calls.
By default the speech units come with the buttons grouped
in twos horizontally to use the single axial button Art. 41110.
This button can actuate one or both mechanical buttons on
the same row.
There is also the single rocker button, Art. 41111, that lets you
actuate the single mechanical button and the double axial but-
ton Art. 41112 which actuates up to 4 buttons.
The (PREVIOUS) and
tween the possible values. If you try to go before the first or
after the last one, the speech unit will emit a tone to warn you
that there are no other valid values.
If you start from a configuration with the LEDs flashing, first
pressing the button (PREVIOUS) will set the first possible
value, while pressing the
possible one.
Article Description
41111 Single rocker button
Single axial button
41110
(default)
41112 Double axial button
Pressing (DEL) takes you back to the previous level,
without saving any changes.
Press (OK) to confirm what you have chosen.
Note: For the 10 button module Art. 41010, by selecting the
Double axial button mode, the last pair of buttons is forced to
Single axial button.
With SaveProg you can change the grouping in a totally arbi-
trary manner, except that the last row of each module cannot
be configured as a Double axial button.
The following figure outlines the configurations of the speech
unit and a button module in the three possible cases and their
respective indoor units corresponding to each group. For
calls, reference is made to the first external module.
28
(NEXT) buttons change be-
button (NEXT) will set the last
LED
Single axial
Single rocker
button
(default)
2
1
3 4
5 6
8
7
9 10
12
11
13 14
The chosen positioning for the indoor units, with gaps in the
numbering, means you don't have to re-code the existing in-
door units or have to re-configure the existing speech units, if
the button grouping is later changed either with this procedure
or with SaveProg.

Advanced configuration (via PC)

The advanced configuration of the electronic module is performed
via a PC, using the "SaveProg" Due Fili system management soft-
ware, available from the website www.vimar.com, and connecting
the electronic module to the PC via a USB-MiniUSB cable.
button Double axial
button
1
1
3
5
5
7
9
9
11
13 13
EN