Write-Protecting Media; Barcode Labels - Sony ODS-L30M Manual De Instrucciones

Cartridge Memory position

Write-Protecting Media

To prevent erasing contents of recorded media
accidentally, slide the Write protect tab on the bottom of
the cartridge (rear of label side) in the direction of the
arrow, as shown in the following figure.
Bottom of the cartridge Write protect tab
Write protect tab settings
Writing
enabled
You can also perform the write-protect settings for media
from the host application.
If either the write-protect tab or the host application is set
to prohibit writing, the media will remain in the write-
protected state.
Writing
disabled

Barcode Labels

The barcode reader of the unit supports CODE39
barcodes. The specifications for supported barcode labels
are given below.
6-digit number
start margin
Dimensions Conformance with label frame size on the
cartridges used
Bar width Narrow bar: 0.432 mm (0.017 in)
Wide to narrow bar ratio
2.75:1
Bar length 11.1 mm (7/16 in)
Quiet zone (start margin/stop margin)
6.35 mm (1/4 in) or greater
Length 8 characters (not including start/stop codes)
Check digit None
Notes
• Attach barcode labels fully within the label area on the
cartridge so that the labels do not stick out, as shown in
the following diagram. Press the barcode label down
firmly so that it cannot peel off.
Label area
• Use commercially available LTO barcode labels (Media
ID: L1).
Media iD
11.1 mm
stop margin
Handling Media
45