Rowenta SILENCE FORCE CYCLONIC Manual Del Usuario página 14

2 • If you have the automatic
model*: automatic cleaning of
the HEP filter and emptying of
the dust container
Cleaning is performed automatically and requires
no action from you. It is carried out when required
when your vacuum cleaner is switched on or off.
NOTE: Your vacuum cleaner makes a clicking
noise during the cleaning operation, this is
(fig.21)
completely normal
We recommend that you empty the dust container
each time after use and/or after cleaning the filter.
Proceed as follows:
- Unplug your vacuum cleaner and open the cover
by pressing the "OPEN" button
(fig.19)
remove the bowl
- Remove the filter assembly composed of the
separator and the filter (3 and 5)
it gently against the side of the bowl to remove
(fig.23)
any excess dust
(fig.24)
container .
- Clean the separator cover using a cloth is if it is
(fig.25)
dirty .
- Refit the filter assembly (3 and 5) inside the dust
(fig.26)
container . Then refit the dust container
into its housing and close the cover of the vacuum
(fig.27)
cleaner .
REM RK
if you notice that the suction
power of your appliance drops, you can force
the automatic cleaning of the HEP filter. In
this case, switch off your appliance and press
the ON/OFF button twice consecutively
(fig.28).
IMPORT NT
Empty the dust container
afterwards.
3 • Servicing the HEP filter
IMPORT NT
The suction power may still
remain unsatisfactory after the mechanical or
automatic cleaning of the HEP filter
(see Cleaning and maintenance paragraph). In
this case it must be cleaned manually.
.
(fig.18)
and
.
(fig.22)
tapping
then empty the dust
In this case, open the vacuum cleaner cover
(fig.18)
, remove the dust container and release
(fig.29)
the HEP filter
Remove the HEP filter (5) from the separator (3)
(fig.30)
and tap the filter above a dustbin
(fig.31)
then clean the outside wall of the filter
under the cold water tap
WARNING Do not place the inside
wall of the HEPA filter under water.
Do not touch or rub the folds of the HEP
filter. Leave the HEP
before refitting it in the appliance.
Refit the HEP filter in the separator
Lock it in position
container into its housing in the vacuum cleaner
and close the cover of the appliance
IMPORT NT
damaged, you may purchase another from
your dealer or from an
Centre (see attached list).
4 • Cleaning your vacuum cleaner
Wipe the body of the appliance and the
accessories with a soft cloth. Wash the dust
container and the separator with clean water
(fig.35-36)
then dry them with a soft cloth
(fig.37)
.
IMPORT NT
abrasive detergent
transparency of the dust container and/or the
separator cover may alter in time but this
does not change the performances of the
appliance.
15
.
(fig.32)
.
filter to dry for 24H
(fig.33)
(fig.34)
. Refit the dust
(fig.27)
If your HEP filter is
pproved Service
Do not use aggressive or
products.
EN
.
.
The