Rowenta SILENCE FORCE CYCLONIC Manual Del Usuario página 15

TROUBLESHOOTING
IMPORT NT
your vacuum cleaner is not operating as well,
before carrying out any checks, switch it off
using the ON/OFF button and unplug the
power cord.
If your vacuum cleaner will not start
• The appliance is not powered. Check that the
appliance is plugged in correctly.
If your vacuum cleaner has no suction power
• n accessory, the tube, the flexible hose or
the pipe between the suction inlet (9) and the
separator are blocked, unblock them.
• The separator cover is blocked: remove the
filter and clean it.
• The HEP filter is dirty: clean it (see Cleaning
and Maintenance paragraph). If the HEP filter
is damaged, change it.
• The cover is not closed correctly: close it.
If your vacuum cleaner has less suction power,
is noisy or makes a whistling noise
• n accessory, the tube, the flexible hose or
the pipe between the suction inlet (9) and the
separator are blocked, unblock them.
• The dust container is full: empty it and wash
it.
• The dust container is not correctly fitted. Fit it
(fig.27)
correctly .
• The filter system (3 and 5) is saturated: see the
Cleaning and Maintenance paragraph. If the
HEP filter is damaged, change it.
W RR NTY
• This product has been designed for domestic
use only. ny professional use, inappropriate
use or failure to comply with the instructions,
the manufacturer accepts no responsibility
and the guarantee will not apply.
s soon as you notice that
• The separator cover (3) is blocked: remove the
filter and clean it.
• The power control switch (16c) is open: close
the power nozzle power switch.
• There is an air leak. Check that the dust
container is locked. Check that the end of the
flexible hose (16d) is fitted correctly. Check that
the filter system is fitted (3 and 5).
If the separator fills up
• Dust accumulates in the bottom of the separator.
Check that the pipe between the bottom of the
separator and the dust container is not blocked.
Remove the filter assembly (3 and 5) and tap it
gently against the side of the bowl to remove any
(fig.23)
excess dust
• The inlet of the dust container is blocked.
Remove the dust container and empty it. Clean
the opening of the dust container (9).
If it is difficult to move the nozzle
• Open the power nozzle power switch (16c).
If the power cord does not rewind completely
• The power cord is slowed down when
rewinding: pull the power cord out again and
press the power cord rewind button.
If a problem persists, take your vacuum cleaner
to your local Rowenta Approved Service
Centre. Check the attached list of Rowenta
Approved Service Centres or contact the
Rowenta customer service.
• Read the instructions for use carefully before
using your appliance for the first time: any
use which does not conform to these
instructions will absolve Rowenta from any
liability.
16 16
.
EN