ELICA Ico BL Manual Del Usuario página 16

T5. Cooking mode.
Press the button cyclically to activate the different suction
modes.
Each mode is associated with different types of food cooking.
This is to obtain optimum suction according to the different
needs.
A signalling LED corresponds to each suction mode.
•
"Slow cooking" mode LED L1 on
Press the button when cooking vegetables in a pan,
when heating food or drinks (milk, coffee, tea).
•
"Boiling" mode LED L2 on
Press the button when cooking sauces, broth, boiled
vegetables and soups, or when boiling food (e.g. pasta).
•
"Grilling" mode LED L3 on
Press the button when cooking food on grill or griddle.
•
"Frying" mode LED L4 on
Press the button when frying food (e.g. meat, potatoes,
vegetables).
To quit the selected suction mode press the following buttons:
Button T1 hood in OFF
Button T2 activation of "Silent" mode
Button T3 activation of "Boost" mode
Fault alarm
In case of motor fault (stall, overheating, etc.) all the functions
of the motor will be blocked (except for lighting) buttons T2,
T3, T5 and LEDs L1, L2, L3, L4 will flash.
Once the alarm has gone off, the hood goes back to OFF.
Press button T1 and the hood passes to OFF.
If the fault persists, the hood remains in the alarm state and all
the functions are blocked. Contact the technical service.
Maintenance
ATTENTION! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Steam screen
The steam screen must always be left closed and opened only
for maintenance (e.g. cleaning or changing filters).
Grease filter
Fig. 13-27
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Open the steam screen.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
Fig. 26
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent, or in a dishwasher at
65°C (if the dishwasher is used, select the full cycle function
and leave dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
• Montage
Open the steam screen and remove the grease filter.
Install the carbon filter on the back of the grease filter and
fix with two rods.
Attention! The rods are included in the carbon filter
packing and not on the hood.
• To dismantle the filter act in the reverse manner.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
16