Oregon Scientific BAR898HG Manual De Usuario página 10

minutes, the pre-alarm will start to operate at 6:15 am (45 minutes
before 7:00 am). The Pre-Alarm icon will flash and the backlight
will be turned on for 5 seconds. An alarm sound will also go off
for 2 minutes as that of the daily alarm and the snooze function
will also be activated if the [ SNOOZE / LIGHT ] button or stand-
button is pressed.
Note: The daily alarm will NOT function until the next day if the
pre-alarm has been triggered beforehand. Deactivation of the
alarm function will disable the pre-alarm feature automatically.
NOTE ON REMOTE READINGS
Once batteries are in place in the remote unit, it will start
transmitting samplings at 40-second intervals. If no signals are
received when the remote sensor display is selected, "--- " will be
displayed. To force the main unit to search for remote sensor
signals, press [ MEMORY ] and [ CHANNEL ] simultaneously.
If that fails, check that the remote sensor is still in place. Make
sure the transmission is within range and the path is clear of
obstacles and interference. Repeat this procedure whenever you
find discrepancies between the display on the main unit and the
display on the remote sensor.
CHECKING INDOOR AND REMOTE
TEMPERATURES & HUMIDITIES
To display the indoor and outdoor temperature and humidity
readings, press the [ CHANNEL ] button to toggle among the
indoor, Channel 1, 2 and 3 displays.
The temperature can be shown in Centigrade (°C) or Fahrenheit
(°F). Select the appropriate reading by using the [
switch (located in the battery compartment). Slide the switch to
°C for Centigrade or °F for Fahrenheit.
If the reading goes above or below the specified amounts, the
display will show a flashing "HHH" or "LLL".
This unit has an auto-scan function that can sequentially display
the indoor and remote readings. To activate this function, press
and hold the [ CHANNEL ] button for 3 seconds. To deactivate
press the [ CHANNEL ] button again.
NOTE ON
The outdoor temperature display on the main unit is dominated
by the selection on the [
Whatever the display unit of the remote sensor is, it will only
apply to the remote sensor itself and the temperature will be
automatically converted to the chosen one of the main unit.
MAXIMUM AND MINIMUM
TEMPERATURES & HUMIDITIES
The maximum and minimum recorded temperatures and
humidities will be automatically stored in memory. To display
them, press [ MEMORY ] . Press [ MEMORY ] again to alternate
between the maximum, minimum and current readings. The
respective MAX or MIN indicator will be displayed.
To clear the memory, press [ MEMORY ] and hold for three
seconds. The maximum and minimum recorded readings will be
9
°
C /
° °
C AND F
° °
C / F ] slide switch of the main unit.
°
F ] slide