Oregon Scientific BAR898HG Manual De Usuario página 9

4. Press [ ] and the minute will flash. Enter the value for the
minute by using [ ] or [
5. Press [ ] to exit.
The alarm will be automatically activated. The ALARM ON icon
[ ] is shown and the alarm will active at the specified time.
To deactivate the daily alarm function, press the [
the alarm time is displayed. The ALARM ON icon will disappear
and [ - : -- ] will be displayed. To activate, press the [
to display the alarm time again.
ALARM AND SNOOZE FUNCTION
When the daily alarm goes off, the backlight will be on for five
seconds and the alarm-on icon will flash.
Initially the active alarm will have a gentle sound. The intensity
will increase in three stages. Without interruption, the unit will
alarm for 2 minutes.
To stop the alarm sound, press any button (expect [ MEMORY ]
& [ CHANNEL ] buttons).
If the [ SNOOZE / LIGHT ] button or stand-button is pressed, the
snooze function will be triggered. The alarm sound will stop and
the alarm-on icon will blink for eight minutes. After that the
alarm will go off again.
To deactivate the SNOOZE function, press the [
] buttons.
] button when
] button
] button.
PRE-ALARM FUNCTION FOR
CHANNEL 1 REMOTE SENSOR
The alarm function also has a pre-alarm feature which can alert the
user before the preset alarm time when weather condition changes.
This pre-alarm function applies to Channel 1 Remote Sensor
only.
To enable this function:
1. First activate the alarm function. Then enter the Pre-Alarm
mode by pressing the [
will be displayed.
2. Press and hold the [
operating time interval for this pre-alarm function. Use the
[ ] or [ ] button to select from the 4 time-intervals: 15, 30,
45 or 60 minutes.
3. Press the [ ] button to confirm and exit. The pre-alarm
function will be enabled automatically which is indicated by
the appearance of the [
4. To disable this function, press the [
mode. The [ ] symbol will disappear and [ - : -- ] will appear
to indicate disable of this function.
The pre-alarm will operate during the selected time interval before
the daily alarm time.
During the pre-alarm operating period, if the temperature recorded
at Channel 1 remote sensor falls to or below 2.0ºC, the pre-alarm
will be triggered. For example, if the daily alarm is set to go off
at 7:00 am and the pre-alarm operating time interval is set to 45
8
] button twice. The "PRE-AL" icon
] button for 3 seconds to set the
] symbol.
] button in the Pre-Alarm