Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING IRON HEATING
CORE ELEMENT
5
4
3
2
1
7
6
Before heater / soldering iron tip replacement make sure that the soldering iron is
completely cold.
1.
SOLDERING IRON TIP REPLACEMENT: remove the nut for mounting the soldering iron tip housing
and take off the housing. Replace the tip with the new one, place the housing and fix all with the
plastic nut.
2.
HEATER REPLACEMENT: remove the nut for mounting the soldering iron tip housing and take off
the housing along with the tip. Remove the nut for fixing the heater (4) and gently remove the heater
(6) along with the board with wires (7). Replace the whole remembering the wires connection order.
REGULAR CLEANING
Generalities
•
Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other
type of cleaning utensil that could damage the surface of the appliance.
•
Before cleaning you must disconnect the plug from electricity supply, isolating the appliance from the
main power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latest is to be found on the technical plate on the device).
•
If relevant, a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. Avoid formulations like "the device doesn´t heat",
which may mean that it doesn´t heat enough or even not at all. These two possibilities have a different
causation!
The more detailed your information, the better the customer service will be able to answer your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a
loss of warranty!
14
EN
1.
nut for mounting the soldering
iron tip housing
2.
soldering iron tip housing
3.
soldering iron tip
4.
plastic nut for mounting the hea-
ter and the board wires
8
5.
spring
6.
heater
7.
wires board
8.
handle
PL
DE
15
Publicidad
Tabla de contenido
