Installation And Operation - BRAVILOR BONAMAT Mnd1-021 Manual De Usuario

1.5 Installation and operation

1. Place the machine on the work
surface.
2. Check whether the machine is
positioned steady and horizontally.
3. Check whether a free wall socket is
available.
4. Slide an empty filter pan (5) into
position and place an empty decanter
(4) beneath it. Attention!
− The lid of the vacuum flask or
airpot must be opened for the TH
model.
− Keep the mixing tube in the flask
when using an airpot.
5. Empty a decanter or measuring jug
(TH model) of cold water in the cold
water reservoir (8).
6. Wait for 3 minutes. (The water forces
all the air out of the machine.)
7. Set all switches (1, and if present also
2) to the off position 0.
8. Put the plug in the wall socket.
9. Switch the machine on by setting the
switch (1) to the on position 1.
4
The green indication lamp (10) lights
up and some of the water that has
been poured in will run into the
decanter.
10. Empty the decanter when the green
light (10) is extinguished.
The machine is now ready for use
Remarks
1. Some water will always remain in the
machine, its hoses, element etc. This
must be taken into account when:
− moving the machine;
− the machine is situated in a room
where the temperature falls below
zero.
2. If for any reason no water is left in the
machine, you must repeat the above
procedure (from step 4 to 10).
WARNING
Ensure the flex does not touch
the heating plate.