A.
Are both tabs inside the han-
dle?
B. Does each clip pass through
both the saddle and handle?
TO ASSEMBLE WHEELS
one side of the air compressor when
installing the wheels because the
compressor will have a tendency to
tip.
1.
Attach wheels with shoulder bolts
and nuts as shown.
Tighten securely. NOTE: The air
2.
compressor will sit level if the
wheels are properly installed.
provide adequate clearance, stability
or support for pulling the unit up and
down stairs or steps. The unit must
be lifted, or pushed up a ramp.
ASSEMBLE RUBBER FEET
1.
Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
2.
Tighten securely.
LOCATION OF THE AIR
COMPreSSOr
•
Locate the air compressor in a
clean, dry, and well ventilated
area.
•
Place on a solid surface to prevent
rocking or tipping.
•
The air compressor should be
located at least 12" (30.5 cm)
away from the wall or other
obstructions that will interfere with
the flow of air.
It will be necessary
to brace or support
The wheels and
handle do not
INSTALLATION
Rubber Foot
Screw
OIL FOR PUMP
pressor was shipped with oil in the
pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
•
The air filter must be kept clear of
obstructions which could reduce
air flow to the air compressor.
•
The air compressor requires fresh
air flow for proper cooling. DO
NOT ALLOW THE COMPRESSOR
TO GET WET.
11 - ENG
Nut
Nut
Flat Washer
Shoulder
Bolt
Risk of Property
Damage. This com-
Wheel