Turn Atomic Clock On / Off; Set Clock; Switch Clock Display; Alarm - Oregon Scientific BAR888RA Manual Del Usuario

STRONG SIGNAL WEAK SIGNAL
To force a manual search for Atomic Clock signals,
press and hold for 2 seconds. If no signal is found,
check the batteries.
NOTE If the Atomic Clock signal is received and the
hour is incorrect, use the timezone offset feature to
adjust it to the appropriate timezone. Please see Set
Clock section for instructions.

TURN ATOMIC CLOCK ON / OFF

Perform this step if you cannot receive Atomic Clock
signals. Press and hold for 2 seconds. Then, manually
set the clock following the Set Clock instructions.
The signal icon indicates that the Atomic Clock
feature is ON. No icon means that it is OFF.

SET CLOCK

You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1. Press and hold MODE for 2 seconds. The Clock
Area will blink.
2. Select the time zone, hour, minute, year, month, day,
NO SIGNAL
NOTE The language options are (E) English, (F)
French, (D) German, (I) Italian, and (S) Spanish.
NOTE The time zone options are (PA) Pacific, (CE)
Central, (MO) Mountain, and (EA) Eastern.

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds
and Clock with Weekday display.

ALARM

This product is equipped with a 2-minute crescendo
alarm.

VIEW ALARM SETTINGS

Press (( )). The alarm time status will show in the Clock
Area.

SET ALARM

1. Press (( )) to switch to alarm display.
2. Press and hold (( )) again for 2 seconds. The alarm
3. Select the hour and minute. Press
8
and language. Press or
Press MODE to confirm.
settings will blink.
change settings. Press (( )) to confirm.
to change the setting.
or to