Hardware Installation; Dsl (Telephone) Port; Lan Port(S) - Conceptronic C150APRA2 Manual De Usuario

ENGLISH

Connect the included antenna to the antenna connection [A] on the back of the modem router.

Connect the power supply to the power connection [D] on the back of the modem router and to an
available wall socket.

Press the power [G] button on the back of the modem router.
The power LED on the front of the modem router will light up and the modem router will perform a
system startup.

3.1 DSL (Telephone) port

Most ADSL providers require a splitter between your phone line and the ADSL modem that prevents the
ADSL line from interfering with regular telephone services. Not using such a splitter could lead to
connection problems or bad performance.
Note: The C150APRA2 is not delivered with a splitter for the ADSL connection. Please contact your
telephone or internet provider for the correct ADSL splitter.
The connection ports of an ADSL splitter are typically labelled as following:
 Line
: This port connects to the wall jack
 ADSL
: This port connects to the router
 Phone : This port connects to a telephone or other telephone device
Make sure the lines are properly connected. If you are unable to hear a dial tone with the telephone,
check the connections to make sure the cables are securely attached and connected to the correct port.
Use a telephone cable to connect the Conceptronic wireless ADSL modem router (B) to your local analog
telephone line (or splitter). The ADSL led will light up when an ADSL signal has been detected.
Note: If the ADSL LED on the front does not lit up, make sure that:
- The wireless ADSL modem router is powered on (the power LED should burn).
- There is an ADSL signal on the line.
- The Internet LED will only be green when correct DSL and user account settings are applied
into the Web Interface of the ADSL modem router.

3.2 LAN port(s)

Connect the network (LAN) cable to 1 of the 4 LAN ports on the back panel of the wireless ADSL modem
routerand to the network card of your computer.
The LAN LED of the used LAN port will lit up, indicating that the computer is connected. (Your computer
must be switched on and the LAN connection must be enabled).
28

3. Hardware Installation