Description; Preparation Before Use; Checking The Oil Level - SDMO DX 6000 TE XL C Instrucciones De Instalación Y Mantenimiento

2. Description

1 Fuel tank
4 Starter-recoil reel
7 Alternator
10 Starter battery
1 On/off key
1 Oil filter
4 Drain plug
1 Fuel tank
4 Fuel filter
7 Decompression lever
1 Wing nut

3. Preparation before use

3.1. Positioning the generating set for operation
Choose a site that is clean, well ventilated and sheltered from bad weather.
Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances
should the set tilt in any direction by more than 10°).
Store the additional supplies of oil and fuel within close proximity, whilst maintaining a certain distance for safety.
3.2. Earthing the generating set
Danger
To connect the set to the ground: Attach a 10 mm
driven 1 meter into the ground.

3.3. Checking the oil level

Before starting the generating set, always check the engine oil level.
Use a funnel to top up with the recommended oil (cf. Specifications section) to the upper limit on the dipstick.
Important
Remove the dipstick/filler plug (diag. B - no. 3) by unscrewing it, and wipe the dipstick.
Insert the dipstick into the filler neck but do not screw it in place.
Check the level and top up if necessary.
Screw the dipstick/filler plug (diag. B - no. 3) fully back into the filler neck.
Check that there are no leaks.
Wipe off excess oil with a clean cloth.
Diagram A
2 On/off key
5 Air filter
8 Earth connection
11 Circuit breaker
Diagram B
2 Starter-recoil reel handle
Diagram C
2 Mounting bolt
Diagram D
2 Level indicator
5 Clips
Diagram E
2 Air filter cover
The generating sets supply electrical current when in operation: risk of electrocution.
Connect the generating set to the ground at each use.
2
copper wire to the set's earth connection and to a galvanised steel earthing rod
3 Engine
6 Silencer
9 Electric sockets
3 Starter-recoil reel
3 Filler cap/dipstick
3 Fuel tank cap
6 Fuel tap
3 Filter element