Mopar 82214276 Instrucciones De Montaje página 2

1. VIN must be updated with the sales code of the added accessory in order to enable system functionality.
Using the DealerCONNECT website and the wiTECH diagnostic application, complete the vehicle configuration.
2. Log on to https://dealerconnect.chrysler.com.
3. In the "Service" tab, inside the Warranty Administration box, locate “Vehicle Option Updates.”
Enter the vehicle VIN and add the sales code “XBM” (Remote Start) as a "Dealer Installed Option".
1. With the WiTECH diagnostic application, perform the following steps:
2. Select the “RF HUB MODULE.”
3. Select the “Data” tab.
4. Write down the names and data values for each of the Tire Sensor ID’s. This will be needed later in the
installation procedure.
4. Confirm that the new sales code has been successfully added to the VIN.
5. With the wiTECH diagnostic application, perform the following steps from the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note on-screen instructions and select the "CLOSE" button
8/1/14
www.mopar.com
2