Ryobi ETMS1825 Manual De Utilización página 9

GB
FR DE ES IT NL
RULES FOR SAFE OPERATION
Do not attempt to stop the saw blade by pushing the
work piece against its side.
Ensure the machine is disconnected from power
before servicing.
Ensure that when turning on (e.g. after servicing) no
tools or loose parts are left on or in the machine.
Turn power OFF if the machine is not in use. Always
unplug the saw from outlet when not in use in a long
time.
CUTTING HAZARD EVEN WITH THE CUTTING
TOOL IS STATIONARY!
Wear gloves when changing the cutting blade.
Store the saw blade(s) in such manner that nobody
can get hurt.
RISK OF KICKBACK (WORK PIECE IS
CAUGHT BY THE SAW BLADE AND THROWN
AGAINST THE OPERATOR):
Ensure the riving knife is correctly set when working
in table saw mode.
Do not jam work pieces.
Make sure the saw blade is suitable for the work
piece material.
Cut thin or thin-walled work pieces only with fine-
toothed saw blades.
Always use sharp saw blades.
If in doubt, check work piece for inclusion of foreign
matter (e.g. nails or screws).
Cut only stock of dimensions that allow for safe and
secure holding while cutting.
Never cut bundes or more than one work pieces
at a same time-the individual pieces cannot be
properly secured and controlled. Risk of personal
injury if individual pieces are caught by the saw blade
uncontrolled.
Remove small cutoffs, scrap, etc, from the work area-
when doing so the saw blade must be at a complete
stop.
ENTANGLEMENT HAZARD!
Be careful that no part of your body or your clothing
can be caught by and drawn into the machine. (no
neck ties, no gloves, no garments with loose-fitting
PT DK SE FI NO RU PL
English
2
CZ HU RO LV LT EE
sleeves; tie back long hair).
Never attempt to cut any work pieces which contain
- ropes
- strings
- cords
- cables or
- wires, or to which any of the above are attached.
HAZARD GENERATED BY INSUFFICIENT
PERSONAL PROTECTION GEAR!
Wear hearing protection
Wear dust mask
Wear suitable work clothes
When working outdoors wearing of non slip shoes is
recommended
RISK OF INJURY BY INHALED WOOD DUST!
Some types of wood dust (e.g. beech, oak, ash) is
harmful to health when inhaled. Use a dust collector
whenever possible. The dust collector must comply
with the data stated in the technical specifications.
Minimize the amount of wood dust escaping from the
machine and the job site into the environment:
- remove wood dust deposit in the work area (do
not blow away);
- fix any leakages on the dust collector;
- ensure good ventilation.
HAZARD GENERATED BY MODIFICATION
OF THE MACHINE OR USE OF PARTS
NOT TESTED AND APPROVED BY THE
MANUFACTURE!
Assemble machine in strict accordance with these
operating instructions.
Use only parts approved by the manufacturer. This
applies particularly to:
- saw blades (see "Technical specifications" for stock
nos.)
- safety devices (see "Technical specifications" for
stock nos.)
Do not change any parts.
H A Z A R D G E N E R A T E D B Y M A C H I N E
DEFECTS!
Keep machine and accessories in good repair. Follow
the maintenance instructions.
HR SI SK GR TR