Tabla de contenido
Publicidad
Thank you for choosing a COMUNELLO AUTOMATION
product.
This manual provides all the detailed information required for
the knowledge and correct use of the equipment. It must
be read carefully at the time of purchase and consulted if
there are any doubts regarding its use or when maintenance
is required.
The manufacturer reserves the right to make any modifica-
tions to the item and to this document without prior notice.
WARNINGS
Please read this manual carefully before beginning instal-
lation and carry out the procedures as specified by the
manufacturer.
This installation manual is only intended for professional
personnel.
Anything not expressly included in these instructions is
prohibited.
In particular, your attention should be drawn towards the fol-
lowing warning:
• Check compatibility of the voltage on the board with the
signal light.
• Disconnect power before making any electrical connections.
• The light source included in this piece of equipment may
only be replaced by the manufacturer or other qualified
personnel.
• The power cord may only be replaced by qualified
personnel.
• This item is not suitable for mounting on surfaces that are
usually flammable.
PRODUCT DESCRIPTION AND INTENDED USE
IXI is an LED beacon used in the automation of gates, sec-
tional doors, overhead doors, barrier systems, etc.
PRELIMINARY CHECKS
• Check that the item inside the packaging is intact and in
good condition.
• Ensure that the installation site allows good visibility, even
from a distance.
• Ensure that the beacon is secured to a solid foundation
and is positioned in a location that is easily accessible for
maintenance.
INSTALLATION
The IXI beacon can be installed directly onto a horizontal or
vertical surface (Fig. 2).
• Proceed as shown in Figure 3-4.
• Drill holes in the base corresponding to the prearranged
areas (see Fig. 5).
• Proceed as shown in Figure 6 using rawlplugs (Ø max
6 mm) and corresponding screws (not included).
• Connect the cables onto the terminals (Fig. 7).
• Insert the cover (Fig. 8).
• Secure the cover with screws (Fig. 9).
At the end of both horizontal or vertical installation, seal with
silicone along the perimeter, inside and outside the base of
the beacon as shown in Fig. 10.
ELECTRICAL CONNECTIONS
Connect the power cable from the control unit to the respec-
tive terminal as shown in Figure 7 using the appropriate con-
nector. Polarities may be reversed.
The IXI beacon allows for a coaxial antenna cable (rg58) con-
nection from the control unit, which must be secured to the
respective connector on the right side (Fig. 7).
Following the procedure illustrated in figures 11 to 14 the
type of light can also be programmed by positioning the
jumper (J3):
Positions 1-2 steady.
Positions 2-3, flashing (factory settings).
ELECTRICAL SPECIFICATIONS
Power supply
LED lamp
Integrated antenna
IP protection rating
DISPOSAL
A number of components of the item can be recycled
while others, such as electronic components, must
be disposed of according to the regulations in force
in the are of installation.
A number of components may contain pollutants that must
not be released into the environment.
11
24Vac / Vdc
24V - 2W
Yes
44
13
12
24Vac/dc
3
2
1
J3
14
Publicidad
Tabla de contenido
