Installation Instructions - Presto 18558 Manual De Instalación

ENGLISH

1) INSTALLATION INSTRUCTIONS

2) Self-supporting framework
3) Sensao washbasin
4) P504-P504S-P704-P2010- P2010S washbasin
5) P1000 XL flush
6) Sensao urinal
7) P120 urinal
8) PRECAUTIONS FOR USE (The product guarantee depends on the respect for these rules)
INSTALLATION and START UP
For products delivered with filters, these must be installed in accordance with the instructions.
Before commissioning any of our valves, it is essential to carefully bleed the pipes Recommended operating pressure according to
NF EN 816: 1 to 5 bar.
CLEANING
The chrome-plated coating of PRESTO® valves must be cleaned only with soapy water.Abrasive, acid, alkaline or ammonia-based
products are prohibited
9) Self-supporting framework flush
10) Framework for P1000 XL hydraulic installation Part no. 18550
Framework for P1000 XL electronic installation Part no. 18551
11) Technical characteristics:
- Male feed G3/4"
- 1/4 turn stop cock
- Automatic flow limiter.
- Junction nose for bowl Ø 55
- Pipe and WC drain ring Ø 90/100
12) The framework must be covered with 2 BA13 plates or 1 BA13 plate + tiling.
Max wall thickness: 56 mm
13) * To be used in case of not very resistant floor
14) Self-supporting framework washbasin
15) Framework for sensao battery washbasin installation
Framework for sensao mains washbasin installation
Framework for P2010 - P2010S - P504 - P504S - P704 installation Part no. 18558
16) Technical characteristics:
- Male feed G1/2"
- Filter shut-off valve
17) Part no. 18558 Max wall thickness: 30 mm
18) Part no. 18554 and Part no. 18556 Max wall thickness: 36 mm
19) For SENSAO installation
20) For P2010 - P2010S - P504 - P504S - P704 installation
21) G1/2" female
22) Self-supporting framework urinal
23) Framework for sensao battery urinal installation Part no. 18559
Framework for sensao mains urinal installation Part no. 18561
Framework for P120 B urinal installation
24) Technical characteristics:
- Male feed G1/2"
- Filter shut-off valve
- Junction nose for Ø 35
25) Part no. 18563 Max wall thickness: 26 mm
26) Part no. 18559 and Part no. 18561 Max wall thickness: 36 mm
27) For SENSAO installation
28) For P120 B installation
29) Installation of 10 l/min limiter for ordinary urinal
30) Provide for a box-out of 130 mm x 130 mm max when installing the partition and tiling.
31) For proper operation of the sensor tapware, avoid installing these products facing a mirror or any other reflective surfaces. Do not
install 2 sensor taps facing one another.
32) This document is not contractual; we reserve the right to modify the characteristics of our products without notice.
33) PATENTED and REGISTERED MODELS
Part no. 18554
Part no. 18556
Part no. 18563