Menu Navigation - OHAUS Pioneer PX323/E Manual De Instrucciones

EN-5
Press the right 0/T button to accept the weight as liquid weight. The density is calculated and result and [gCC] are
shown alternately.
Press the right 0/T button to stop the blinking and go back to ready status.
Begin Density Liquid mode-The display shows [Air] and [wWeigHt] alternately. Place the sinker on the on density
determination kit, the display shows the weight value.
Press the right 0/T button to accept the weight as air weight.
The display shows [Liguid] and [wWeigHt] alternately. Place the sinker on the density determination kit (in the
liquid), please make sure that the entire sinker is submerged in the liquid, the display shows the weight value.
Press the right 0/T button to accept the weight as liquid weight. The density is calculated and result and [gCC] are shown
alternately.
Press the right 0/T button to stop the blinking and go back to ready status.
3.6 Weigh Below Feature
Remove Weigh Below Cover
4. SETTINGS

4.1 Menu Navigation

.CAL. .SETUP.
InCal* AZSM
SPAN FILTER
**
LINEAR A.TARE
CAL ADJ GRAD
END.CAL GBL RST
END.SET
* InCal models only
** Not available in InCal models
Attach wire or string to Hook
.MODE. .UNIT.
COUNT GRAM
COUNT
PERCENT MILLIGRAM
APWOPT
KILOGRAM
PERCENT
DYN
END.MOD OUNCE
DENSITY
POUND
END.MOD
NOT ALL
CUSTOM
UNITS
SHOWN
NO
NOT ALL
UNITS SHOWN
YES
END.UNIT
Suspend sample
.END.
.PRINT. .RS232.
OUT STA BAUD
A. PRINT PARITY
CONTENT HAND.SH
LINE FO END.R232
END.PRT
Pioneer
™
.LOC.
CAL
SETUP
MODE
UNIT
PRINT
RS232
END.LOCK