Publicidad
Idiomas disponibles
Idiomas disponibles
MetalliFinder Pro
Metal Search:
Press the ON/OFF button (d.) in order to activate Metal Search.
When Metal Search is activated, the symbol for the selected
mode (2. - 4.) appears in the display.
AC Search AC:
Press the ON/OFF button (d.) in order to activate AC Search.
When AC Search is activated, the AC symbol (1.) appears in
the display.
3. Calibration:
Press the CAL (e.) button to automatically calibrate the tool
in the selected mode. The CAL (5.) symbol appears for about
2 secs. in the display. When calibration has been successfully
completed, the symbol READY (6.) is displayed, if an error has
occurred, this is indicated by the symbol ERROR (7.).
Tip 1: Calibration error: If calibration is unsuccessful, this is
probably because the tool is located directly above an object
of the kind being searched for. Move the device to a different
position on the surface and try calibrating once more.
Tip 2: Detection error: To avoid detection errors, the
MetalliFinder should be kept in contact with the relevant
surface throughout the detection process.
4. Switching-off:
Press the Set and ON/OFF buttons (c, d) simultaneously. The
tool automatically switches off about 2 minutes after the last
search operation.
Scan modes:
A. Metal Search, Depth Measurement:
Metal Search offers three different detection modes which
are optimised for the different materials concerned. Select the
desired mode using the set button (c.).
Structural steel
Iron pipes
Copper pipes
Your selection is shown on the display by means of symbols
(2) to (4).
07
GB
Publicidad
