Fueling The Unit; Chain Oil - Omega Mugello 2525 Manual De Instrucciones

FUELING THE UNIT

1. Untwist and remove the fuel cap. Rest the cap on a dustless
place.
2. Put fuel into the fuel tank to 80% of the full capacity.
3. Fasten the fuel cap securely and wipe up any fuel spillage around
the unit.
1. Select bare ground for fueling.
2. Move at least 10 feet (3 meters) away from the fueling point
before starting the engine.
3. Stop the engine before refueling the unit. At that time, be sure to
sufficiently agitate the mixed gasoline in the container.
FOR YOUR ENGINE LIFE, AVOID:
1. FUEL WITH NO OIL( RAW GASOLINE)
– It will cause severe damage to the internal engine parts very
quickly.
2. GASOHOL
– It can cause deterioration of rubber and/or plastic parts and dis-
ruption of engine lubrication.
3. Oil FOR4-CYCLE ENGINE USE
– It can cause spark plug fouling, exhaust port blocking, or piston
ring sticking.
4. Mixed fuels which have been left unused for a period of
one month or more may clog the carburetor and result in the engi-
ne failing to operate properly.
5. In the case of storing the product for a long period of time, clean
the fuel tank after rendering it empty. Next, activate the engine and
empty the carburetor of the composite fuel.
6. In the case of scrapping the use mixed oil container, scrap it only
at an authorized repository site.
WARNING
NOTE: As for details of quality assurance, read the des-
cription in the section Limited Warranty carefully. Moreo-
ver, normal wear and change in product with no functional
influence are not covered by the warranty. Also, be carefeul
that if the usage in the instruction manual is not observed
as to the mixed gasoline, etc described therein, it may not
be covered by the warranty.

CHAIN OIL

We recommend that you use our specific oil for
chains: Ref.: 6000849 and ref.: 6000850.
NOTE: Do not use wasted or regenerated oil that can cau-
se damage to the oil pump.
9 9
EN