Omega Mugello 2525 Manual De Instrucciones página 39

After each cutter has been filed, check the depth gauge and file it
to the proper level as illustrated.
Appropriate gauge checker
Depth gauge
standard
BE SURE TO ROUND OFF THE
FRONT EDG TO REDUCE THE
CHANCE OF KICKBACK OR TIESTRAP
BREAKAGE.
Make sure every cutter has the same length and edge angles as
illustrated.
Cutter length
Make the
shoulder
round
Filing angle
Side plate angle
Top plate cutting angle
Guide bar
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be square. Check for wear of the bar
rail. Apply a ruler to the bar and the outside of a cutter. If a gap is
observed between them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
Ruler
Gap
17 17
EN
No gap
Chain tilts