Vision Engineering Mantis Guia Del Usuario página 9

Routine Maintenance
Desiccant Replacement
The desiccant removes excess moisture from the optical head.
X Disconnect the power supply from the bottom of the head.
X Remove the grommet covering the desiccant and remove the desiccant.
u
X Insert the new desiccant and replace the grommet.
LED Arrays
The method for removing the LED arrays is identical for
either side.
X Disconnect the power supply from the bottom of the head.
X Loosen the two screws that secure the filter/array cover
v
X Remove the three screws
that secure the LED array.
y
X Lift out the LED array
and turn it over. Disconnect the array connector
z
X Reassembly is the reverse of this procedure.
General Care
X Cover your Mantis with a dust cover when not in use.
X Remove dust with a soft brush or cleaning cloth.
X The Mantis viewing screen and lenses should be cleaned with a lens cleaning cloth.
X Keep accessories in a dust-free environment when not in use.
Service
Service and repair work must only be carried out by service engineers authorised by Vision Engineering.
Specification
Objective Lenses
Objective Lenses
x2
x4
x6
x6 SLWD
x8
x10
x15
x20
Lighting Data
LUX intensity measured at subject plane with colour correction filters
24 LEDs
Substage illumination (bench stand only)
58 LEDs
Warranty
This product is warranted to be free from defects in material and workmanship for a period of one year from the date of invoice to the original purchaser.
If during the warranty period the product is found to be defective, it will be repaired or replaced at facilities of Vision Engineering or elsewhere, all at the option of Vision
Engineering. However, Vision Engineering reserves the right to refund the purchase price if it is unable to provide replacement, and repair is not commercially practicable or
cannot be timely made. Parts not of Vision Engineering manufacture carry only the warranty of their manufacturer. Expendable components such as fuses carry no warranty.
This warranty does not cover damage in transit, damage caused by misuse, neglect, or carelessness, or damage resulting from either improper servicing or modification by
other than Vision Engineering approved service personnel. Further, this warranty does not cover any routine maintenance work on the product described in the user guide or
any minor maintenance work which is reasonably expected to be performed by the purchaser.
No responsibility is assumed for unsatisfactory operating performance due to environmental conditions such as humidity, dust, corrosive chemicals, deposition of oil or other
foreign matter, spillage, or other conditions beyond the control of Vision Engineering.
Except as stated herein, Vision Engineering makes no other warranties, express or implied by law, whether for resale, fitness for a particular purpose or otherwise. Further,
Vision Engineering shall not under any circumstances be liable for incidental, consequential or other damages.
www.visioneng.com/support
, remove the cover and then the filter
w
and remove the LED array.
{
Working Distance Field of View
160mm 57.0mm
96mm 34.0mm
68mm 23.0mm
112mm 20.0mm
59mm 17.0mm
54mm 13.5mm
40mm 8.8mm
29mm 6.5mm
11,000 LUX 10,000 hours
2,700 LUX 10,000 hours
v
x
w
y
v
u
.
x
Power Supply
100-240VAC 50-60HZ 1.0A Max
Accessories
Lens protection caps
Floating Stage (for bench stand only)
Dust Cover
Replacement surface LED array
Mantis Elite with Bench Stand - User Guide
MANTIS ELITE
{
z
9