Sanus Systems WMS3 Instrucciones De Montaje página 5

3] Final Assembly.
A] Place the Wall/Speaker Plate Hardware Covers (e) onto the Wall/Speaker Plates (a).
B] If you are using the Ceiling Extension (b) place it onto the Wall/Speaker Plate next. Tighten the allen set screw until
it is snug. If you are not using the Ceiling Extension skip to step C.
Warning: Do not overtighten! Continuing to tighten the allen set screw once it is snug will not make the
connection stronger.
Diagram for step A]
Wall/Speaker Plate (a)
C] Put the Arm Assembly into place and tighten the allen set screw until it is snug.
Warning: Do not overtighten! Continuing to tighten the allen set screw once it is snug will not make the
connection stronger.
D] Remove the Arm Assembly Hardware Covers (f). Use the allen key to loosen the bolt. Adjust the angle of the Arm
Assembly to the desired position and retighten the bolt.
Warning: Adjusting the angle of the Arm Assembly without loosening the bolt will reduce the ablility of
the bracket to maintain it's position over time.
E] Replace the Arm Assembly Hardware Covers.
Note: There is one angled surface on both the Arm Assembly and the Hardware Cover. These surfaces should
be aligned.
Diagram for step C]
Allen Key (r)
Arm Assembly (c)
Wall/Speaker Plate (a)
F] Attach the speaker with the Speaker Plate to the assembly at the desired angle and tighten the allen set screw.
Warning: Do Not Overtighten! Continuing to tighten the allen set screw once it is snug
will not make the connection stronger.
Diagram for step F]
Arm Assembly (c)
Diagram for step B]
Wall/Speaker Plate Hardware
Covers (e)
Diagram for step D]
Allen Key (r)
Wall/Speaker Plate (a)
Allen Key (r)
Ceiling Extension (b)
Diagram for step E]
Arm Assembly (c)
Arm Assembly Hardware
Cover (f)
Angled Surface
Arm Assembly Hardware
Cover (f)