Heater Control - PURLINE CHD222J Manual De Empleo

3. Termostat knob

HEATER CONTROL

OFF
1. Carefully remove your heater from the box and
bag.
OFF
STOP
FAN ONLY
LOW 1200W
HIGH 2400W
OPERATION :
17
2. Make sure that the heater is in the OFF (0)
position before plugging the heater into a outlet.
3. Place the heater on a firm, level surface.
4. The power light will light up when initially
plugging the heater into a outlet.
5. For heater operation, set the Thermostat knob to
the maximum setting (+).
6. Set Power knob to the desired heat setting. Low
heat (1200W) is represented by the I and High
heat (2400W) by the II.
7. For fan-only operation, without any heat output,
turn Power knob to the fan setting represented by
.
8. The Power light will remain lit during operation.
9. To disconnect heater, turn Power knob to the OFF
(0) operation. Then remove the plug from the
outlet.
WARNING : METAL MESH IS HOT WHEN
HEATER IS IN OPERATION
THERMOSTAT KNOB
18
.