Initial Use; Trimming / Connecting The Led Tape; Installing The Led Strip - LIVARNO LUX 14109500L Instrucciones De Montaje

Safety / Initial use / Installing the LED strip
Prevent fire and injury
hazards
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced.
If the LEDs cease to function at the end of their
operational life, the entire item must be replaced.
The installed LEDs are not suitable
for dimmers or electronic switches.
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
Safe working
Do not leave the LED strip or packaging mate-
rial lying unattended. The packaging material
presents a suffocation hazard and there is a
risk of loss of life from strangulation.
Install the light so that it is protected from dirt
and excessive heating.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never use the LED strip if you are having diffi-
culty concentrating or do not feel well.
Before use, familiarise yourself with all the in-
structions and diagrams in these instructions, as
well as with the LED strip itself.
To completely disconnect the LED strip from
the power supply, the mains adapter must be
removed from the mains socket.

Initial use

Remove all packaging materials before first
use.
Never connect the LED strip to the mains power
supply whilst in the packaging.
14 GB/IE
Trimming / connecting
the LED tape
The LED tape may be trimmed to size or connected.
DANGER TO LIFE BY ELEC-
TRIC SHOCK! Disconnect the lights from the power
supply before performing any work on the LED strip
. Remove the mains plug
3
socket.
Choose the desired LED strip length.
Note Ensure that you cut the LED strip at the
right place. The cutting point lies exactly between
the plus and minus pole and is marked with a
black line (Fig. B).
Shorten the LED strip
Then press both ends of the LED strip
the displacement contact of the plug connec-
tion (see Fig. C).
4
Ensure the correct polarity (+ 12 V ~ <-> +
12 V ~ ) here.
Then press one end cap
ends of the plug connection
Check the correct positioning.
Be sure to cover the open end of the LED tape
with the adhesive strip
3
wish to connect the end after trimming the tape
(See Fig. D).

Installing the LED strip

Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Note: Ensure that a plug socket is located in close
proximity to the installation area.
Choose a suitable installation area (window
etc.).
Remove the protective foil from the reverse side
of the LED strip .
3
Stick the LED strip
onto the installation area and press it on firmly.
Remove the protective foil from the reverse side
of the cable hold
6
Stick the cable hold
tion.
from the mains
1
using a pair of scissors.
3
onto
3
at a time onto the
5
(See Fig. C).
4
if you do not
7
with the adhesive strip
3
.
onto the desired posi-
6